Mitsubishi QCPU (Q Mode) User Manual

9 - 8 9 - 8
MELSEC-Q
9 PARAMETER LIST
Table 9.1 Parameter List (continued)
Item Parameter No. Description
Network parameter
Designates parameters for MELSECNET/H, Ethernet and CC-
Link.
MELSECNET/H setting
1
No. of boards in module 5000
H
Valid module during other
station access
5001
H
Interlink transmission parameter 5002
H
Routing parameters 5003
H
Network setting 5NM0
H
Refresh parameters 5NM1
H
Common parameter 5NM2
H
Station inherent parameter 5NM3
H
Common parameter No.2 5NMA
H
Station inherent parameter
No.2
5NMB
H
Designates network parameters for MELSECNET/H.
Ethernet setting
1
No. of boards in module 9000
H
Starting I/O No.
Network No.
Operational settings
Initial settings
Open settings
Routing information
MNET/10 routing information
FTP Parameters
E-mail setting
9N00
H
Designates network parameters for Ethernet.
CC-Link setting
2
No. of boards in module C000
H
Remote input (RX)
Remote output (RY)
Remote register (RWr)
Remote register (RWw)
Special relay (SB)
Special register (SW)
CNM1
H
Start I/O No.
All connect count
Retry count
Automatic reconnection
station count
Stand by master station No.
PLC down select
Scan mode setting
Delay information setting
Station information setting
Remote device station initial
setting
CNM2
H
Designates network parameters for CC-Link.

Mitsubishi QCPU (Q Mode) Specifications

General

Brand	Mitsubishi
Model	QCPU (Q Mode)
Category	Controller
Language	English