4 - 24 4 - 24
MELSEC-Q
4 SETTINGS AND PROCEDURES PRIOR TO OPERATION
4.6 Settings with the Utility Package (GX Configurator-SC)
The settings defined with GX Configurator-SC for operation of the Q series C24 are
described in Chapter 8.
The following concerns the data set from GX Configurator-SC.
1) Data set in the Q series C24 for the use of specific functions
2) Data set in the programmable controller CPU to communicate information between
the Q series C24 and the programmable controller CPU of the mounting station.
This section explains the "Auto refresh settings" of the data mentioned in 2) above.
[Setting purpose]
The auto refresh settings are defined to automatically store the information stored
in the buffer memory of the Q series C24 in devices designated by the
programmable controller CPU.
By this setting, the users can see the module information without accessing the Q
series C24.
[Setup procedure]
[Tools] [Intelligent function utility] [Start] "Select a target intelligent
function module" screen
Auto refresh .
For display screen, see Section 9.3.
[Setting screen]
To Next Page
Loading...
