8 - 17 8 - 17
MELSEC-Q
8 DATA COMMUNICATION USING THE PRE-DEFINED PROTOCOL
(b) Setting on GX Configurator-SC (pre-defined protocol support function)
Set the protocol explained in Section 13.5.2.
1) From the menu bar, select [File]→[New].
2) The "Add protocol" screen is displayed.
Select the following protocol, and click the OK button.
3) The "Protocol setting" screen is displayed.
Click the cell under "Packet setting" (displayed in red) of "Packet Name"
H7B:RD Operation Mode.
Click
4) The "Packet setting" screen is displayed.
Click the cell under "Element setting" (displayed in red) on the Element
No. 2.
Click
To Next Page
Loading...
