Index - 2 Index - 2
[O]
ONDEMAND.............................................. 10-3
Operation mode....................................... 11-14
OUTPUT .................................................... 10-7
[P]
P/S ........................................................... 11-43
Parity bit ..................................................... 4-16
Part names and functions .......................... 4-3
PRO. ........................................................ 11-44
Pre-defined protocol. ................................... 8-1
"SD" LED. ............................................. 11-39
Data communication procedure............... 8-3
Protocol cancellation. ............................... 8-6
Number of protocol executions. ............... 8-6
Pre-defined protocol monitor/test............. 8-6
Execution log options. .............................. 8-7
Protocol execution log storage function... 8-7
Processing time .....................................App-16
[Q]
QnA/A series module ..............................App-8
[R]
Reading the data communication status
................................................................. 11-11
Reading the RS-232 control signal status
................................................................. 11-10
Reading the switch setting status ........... 11-12
Receive area (bidirectional) ........................ 7-4
Receive area (non procedure) .................... 6-6
Receive complete code setting ................. 6-21
Receive data (bidirectional)......................... 7-6
Receive data (non procedure) .................... 6-8
Receive data clear (bidirectional).............. 7-14
Receive data clear (non procedure) ......... 6-15
Received data count.................................. 6-21
Receiving methods (bidirectional)............... 7-2
Receiving methods (non procedure) .......... 6-2
ROM/RAM/switch tests ............................. 4-27
RS-232 interface specification .................... 3-3
RS-422/485 interface specification ............. 3-7
"RUN" LED .............................................. 11-36
Remote password check.................... 1-11, 5-4
[S]
Serial communication module .....................1-1
Setting for GX Developer...........................4-14
Settings and procedures prior to operation
......................................................................4-2
Simultaneous transmissions......................7-24
SIO............................................................11-45
SPBUSY ...................................................10-29
Starting the utility........................................9-13
Station number setting ...............................4-19
Sum check code.........................................4-17
Switch setting .............................................4-15
System configuration ...................................2-5
System registration to flash ROM..............9-19
[T]
Transmission area (bidirectional) ..............7-16
Transmission area (non procedure) ..........6-24
Transmission data (bidirectional)...............7-18
Transmission data (non procedure) ..........6-26
Transmission methods (bidirectional)........7-15
Transmission methods (non procedure) ...6-23
Transmission setting ..................................4-16
Transmission specification...........................3-1
Troubleshooting .........................................11-1
[U]
Uninstalling utility package ..........................9-4
Utility package ..............................................9-1
Utility package operation .............................9-9
[1]
1:1 system configuration ..............................2-5
1:n.................................................................2-6
Ind
To Next Page
Loading...
