Mitsubishi S4E - Page 105

(3) Drive out tapered pin (4) by using' drift, as
shown, and pull drfv e g<ar (5) off main sh,ft (6).
Dr.w the main shaft out of the pwnp case.
4-Tap~re:d p in 6--Main $haft
5--0r iv. gs:ar
Removing tapered pin
(4) Drive out inn.r rotor pin (7), and separate main
ahafl (6) from inner rotor (8).
6·Main shaft
B·lnner ro(O(
''''nnltr rOtor pin
Re-mmdng Inner rotor pin
Oil pump reassembly
After securing inner rolor to shaft by driving in Ille pin,
insert the. shaft in to the pump case, and mou.n t the gear
on Ille Sha ft, locking the gear by driving in the tapered
pin.
DI SASSE MBL Y AND REASSEMBLY
l
, -Pump dri \Je gear
:2 .M ll in shiloh
3-Pymp ce:oe
/
3
4
5
4~ute, to lor
G-Innl!lr rotor
Oil pump - Cross $ecticm
Mounting drive gea r
Fin in g cover to case by match i ng ma rks
99