MODELS: WS-48315 / WS-55315 / WS-65315
Page 15
SERVICING THE DIAMONDSHIELD™
1. DiamondShield Removal Procedure
The location of the DiamondShield molding clips may vary between models, top and bottom, or sides. Use
the appropriate disassembly procedure given below.
Note: Wear gloves when handling the DiamondShield to prevent finger prints.
1. Gently insert a small screwdriver between the
DiamondShield and one end of the clip to pry
the clip loose.
2. Remove both clips by pulling them toward you.
3. Carefully insert a small screwdriver into the gap
at the top/center point of the Shield and pull the
Shield slightly away from the unit. Place your
hands at the points shown and gently bow the
Shield toward you and remove from the unit.
Then re-install the two clips.
Top & Bottom Molding Clips
Side Molding Clips
1. Gently insert a small screwdriver between the
DiamondShield and one end of the clip to pry
the clip loose.
2. Remove both clips by pulling them toward you.
3. Carefully insert a small screwdriver into the gap
at the side/center point of the Shield and pull the
Shield slightly away from the unit. Place your
hands at the points shown and gently bow the
Shield toward you and remove from the unit.
Then re-install the two clips.
2. DiamondShield Installation Procedure
*(See the Parts List for DiamondShield part numbers)
To install the DiamondShield, reverse the above Removal Procedure.
To Next Page
Loading...
Need help?
General
