Miyachi MG3D - 7 Appendix; Error Messages

Operating Instructions MG3 Digital
Appendix
76609409EN-BA-MG3D-V1_6.docx 77/82 2010-08-02
7 Appendix
7.1 Error messages
No. Error Cause
4001
4002
Open file CF or file damaged
4003
Save file CF or file damaged
4004
Wrong file type or file faulty xxx is wrong, or faulty file header
4005
4006
Access to BAT RAM Battery exhausted
4007
Load file See 4002
4008
File already existing and write-
protected
On overwriting write-protected file
4009
4010
4011
4012
4013
4014
4015
4016
4017
4018
4019
4020
CAN: Timeout data read Data transfer overloaded, possible
causes:
measuring interval too short
too intensive rotary transducer
Actuation during highly frequented
measurements
4021
CAN: Timeout data write Data transfer overloaded, possible
causes:
measuring interval too short
too intensive rotary transducer
Actuation during highly frequented
measurements
4022
CAN: Timeout receive request
4023
CAN: Timeout send request
4024
CAN: Overflow job buffer Bottleneck executing several tasks,
possible cause:
display of too many graphics during
strongly frequented measurements
4025
4026
4027
4028
4029