Mocom Exacta - Page 63

EXACTA
55
TROUBLESHOOTING
used water has been cycled.
The red warning LED
MIN flashes
Lack of water in the charge
tank (< 1 liter).
Top up the charge tank with 1 liter of distilled
water until the LED MAX turns on.
The timer display
shows one of the fol-
lowing messages:
A2
A3
A4
A5
A7
A2-A5: hydraulic fault
A3: temperature probe
fault or out from the
temperature range
during the cycle
A4: heating resistance
fault
A7: vacuum pump fault
A2-A5: open the door, clean the gasket and
try to start the cycle.
A3: switch-off the equipment and try to
start again. If the failure goes on call
the Technical Service
A4: open the door, verify if the safety
thermostat is on and try to start the
cycle.
A7: open the door, empty the gathering
tank and top up the main tank with
distilled water; try to start the cycle.
Note: for any alarm indication Ax, please call
the Technical Service.