05/06 AWB2724-1584GB
Connecting outputs
21
Connecting outputs
The relay or transistor outputs can be used to switch loads, such
as fluorescent tubes, filament bulbs, contactors, relays or motors.
Prior to installation observe the technical limit values and data for
the outputs (a page 72, 73).
Connecting relay outputs
EC4P-221/222-MR…, EASY6..-DC-RE
Unlike the inputs, you can connect the EC4P-221/222-MR…,
EASY6..-..RE relay outputs to different phase conductors.
Figure 21: Relay outputs EC4P-221/222-MR…
+ 24 V H
0 V H, N
F
8 A/B 16
L1, L2, L3 (115/230 V h)
25 000
R
24 V H 8 A
115 V h 8 A
230 V h 8 A
2A
2A
2A
1000 W
10 x 58 W
12 2 2 2 2 2
1
1
1
1
1
10 000 000
Q6Q5Q4Q3
Q2
Q1
i
Caution!
Do not exceed the maximum voltage of 250 V AC on a
relay contact. If the voltage exceeds this threshold,
flashover may occur at the contact, resulting in damage to
the device or a connected load.
To Next Page
Loading...
Need help?
General
