05/06 AWB2724-1584GB
Memory card, CAN/easy-NET,
PC connection
23
Memory card, CAN/easy-NET, PC connection
To fit a memory card or establish a CAN/easy-NET or PC
connection the protective cap must be removed first of all.
Fitting or removing the memory card
The memory card is located in adapter c.
X To fit the memory card, press it until it snaps into position.
X To remove the memory card, press it until it is released.
CAN/easy-NET, PC connection
X Fit the plug for the CAN/easy-NET connection into the opening
at the top of the device a.
X Fit the plug for the PC connection in the opening on the bottom
right on device b.
Figure 24: Removing the protective cap/adapter: top: for CAN/easy-
NET connection bottom left: adapter for memory card
bottom right: PC connection
Figure 25: Adapter with memory card
c
Figure 26: Fitting/removing the memory card
Figure 27: Plugs for CAN/easy-NET connection a and the PC
connection b
h
For further information see a section “CAN/easy-NET
network”, page 65.
h
Attention!
Protect the EC4-200 and memory card from electrostatic
discharge in the following manner: Discharge yourself of
electrostatic charge by touching a grounded surface
before fitting or removing the memory card.
1
2
b
a
To Next Page
Loading...
