Moeller EC4-200 - Changing Parameters; Deleting the Startup.ini File

Defining system parameters
via the STARTUP.INI file
05/06 AWB2724-1584GB
58
Changing parameters
The parameters are retained until you enter the browser command
“removestartupini” and then switch the controller off and on
again. The controller will now operate with the parameters of the
project.
Deleting the Startup.INI file
The following browser commands can be used to access the
memory card.
• removestartupini:
Always deletes the controller system parameters. If a memory
card is fitted, the INI file is also deleted on the memory card. The
parameters are loaded from the project at the next startup.
• removeprojfrommmc:
Deletes the boot project and the INI file on the memory card.
The system parameters are retained in the controller.
•format:
Deletes the entire memory card incl. INI file.
The behaviour of the Startup.ini file with the Hard Reset and
Factory Set menu commands on the controller and with the
“factoryset” browser command is described in a section
“Reset” on page 38.