Programming
EPM2000/EPM2000e Reference Guide
34
IDENTIFICATION
Query the EPM2000 for identifying information, such as firmware revision date, model number, etc.
Command Form
*IDN?
Example
Input Instrument Reply
*idn? Molectron Detector, Inc.
EPM2000 Ver G4.30 13-Aug-98†
† Actual reading will vary, depending on installed firmware.
IEEE-488 ADDRESS
Set or query the IEEE-488 address of the EPM2000. The instrument must be reset for this command
to take effect.
Command Form
COMMunication GPIB ADDRess <?|0..31)
Examples
Input Instrument Reply
comm gpib addr 5 none
comm gpib addr ? COMM: GPIB: ADDRESS 5
INSTRUMENT SETUP STORE/RECALL
Set the EPM2000 to store certain instrument attributes in or retrieve those attributes from a
numbered memory location. Both channels are stored and recalled, so no channel argument is
required. The stored attributes are Average Batch Size, Display Speedup, Line Frequency,
Pyroelectric Rv, Range, Statistics Batch Size, Statistics Restart Mode, Trigger Holdoff, Trigger Level,
Trigger Source, and Units. Memory locations 1, 2, 3, or 4 are available.
Command Form
CHannel MEMory <STORE|RECALL> <1|2|3|4>
Examples
Input Instrument Reply
ch mem store 1 none
ch mem recall 1 none
To Next Page
Loading...
Need help?
General