Money Controls MechTool SR5 - Teach and Run Token 12 - Position F; Teach and Run Coins

SR5 MechTool
TM
Manual TSP012.doc Issue 2.1 – June 2004
©Money Controls 2004. All rights reserved.
Page 12 of 24
8. Teach and Run
TM
Token 12 - Position F
Position F allows a token, which is not currently in one of the pre-programmed groups, to be
programmed on site.
To Teach and Run™ token 12, ensure that the SR5 is powered up through the main parallel
connector.
To use:
¾ Turn the rotary switch to position F.
¾ Press and hold the program button, the LED will change to RED.
¾ Release the program button.
¾ The LED will change to YELLOW/RED.
¾ Insert several of the coin type to be programmed, typically eight coins, until the
LED flashes GREEN.
¾ Press and hold the program button, the LED will stop flashing.
¾ Turn the rotary switch to position C.
¾ Press and hold the program button, the LED will change to RED.
¾ Release the program button.
¾ The LED will change back to GREEN.
Note: If the LED stays Green then Teach and Run ™ Token 12 is not available.
If an error occurs during programming then the LED will change to Red. Press the program
button, the LED will change to Green. The token that was previously programmed will still
accept.
To stop programming before the LED changes to flashing Green, remove and then re-apply
power to the SR5.
The token that was previously taught will still accept.
NEVER leave the validator with the rotary switch in positions D, E or F.
8.1 Teach and Run™ Coins
The SR5 allows the teaching of all 16 coin positions.
For details please see Flow Chart 1: Teach Coin Mode.