MONOGRAM
REFRIGERATORS
INSTALLATION
Complete
detailed
Installation
Instructions
are supplied with each
refrigerator.
Refer
to
these
instructions
before
installing
refrigerator.
Electrical Connection
A
115
volt
electrical
receptacle should
be
provided in the wall behind the unit
compartment, near the center.
CAUTION:
Care
should
be
taken
when
disconnecting the
power
cord to avoid
contacting
refrigeration
system
tubing
which
may
be
extremely
warm.
ZIS
MODELS
WARM
Before connecting the
power
cord to the receptacle, turn the freezer temperature
control to the "off"
position.
Then,
after
connecting the
power
cord,
set
the
control
to
position "5".
Water
Connection
Copper
tubing (1/4-inch
0.0.)
must
be
connected to the tubing connector provided
on
the
inlet
of
the water valve.
The
valve
is
located behind the base panel.
The
water valve should
be
connected
to
a
frequently
used
cold water
line
with
pressure
between
15
and
120
PSIG.
A
shut-off
valve, having a
minimum
5/32-inch
inside diameter, should
be
provided
at
the
connection to the water supply
line.
NOTE:
If
the
refrigerator
is
to
be
operated before the water supply
has
been
connected, the
icemaker
should
be
set
to
the
"OFF
OR
STOP"
position.
- 1 -
To Next Page
Loading...
