Moons' SS03-S-A User Manual

27
Rev. 1.1
0004102014
400-820-9661
SS03/05/10-S/Q/C Hardware Manual
3.1.3 X5/EN, X6/AR,X7 and X8 Digital Inputs
The X5/EN, X6/AR,X7 and X8 are digital inputs operation 5-24V optically isolated single-ended
signal.
;FDQEHFRQ¿JXUHGDVHQDEOHVLJQDOLQSXWWRH[FLWHWKHPRWRUDQG;FDQEHFRQ¿JXUHGDV
alarm reset signal input to clear the alarm and turns to the normal status as servo off.
,QWKHYHORFLW\PRGH;FDQDOVREHFRQ¿JXUHGDVVSHHGVZLWFKVLJQDOWRFKDQJHWKHVSHHGWR
another one.
;DQG;FDQEHFRQ¿JXUHGDVJHQHUDOSXUSRVHLQSXWIRU:,2,)6RU6+DQGRWKHUFRPPDQGV
Because the input is an optically isolated circuit, a 5-24V power supply is needed. For example,
you can use the power supply of the PLC when you are using a PLC control system,but if you
want to connect a relay or mechanical switch to the input ,you must need a power supply.
XCOM is an electronics term for an single-ended signal connection to a common voltage. In the
case of SS series, if you are using a sourcing(PNP) input signals, you need to connect XCOM
to the ground(power supply -),if you are using a sinking(NPN) input signals ,the XCOM need to
connect to the power supply +.
NOTE:
If current is Àowing into or out of an input ,the logic state of that input is low or closed.
If no current is Àowing ,or the input is not connected,the logic state is high or open.
The chats below show how to connect to EN and AR. Please select the polarity of the inputs by
using the Step-servo Quick Tuner.
5-24VDC
Power Supply
Connecting to a Switch or Relay
XCOM
X5/X6/X7/X8
+
-
Switch or Relay
(Closed: logic low)
SS-S-Q-C
5-24VDC
Power Supply
XCOM+
-
+
-
output
SS-S-Q-C
X5/X6/X7/X8
Connecting a NPN type output to an Input
NPN
Type
Output
+
-
+
-
output
SS-S-Q-C
X5/X6/X7/X8
XCOM
Connecting a PNP type output to an input
PNP
Type
Output
5-24VDC
Power Supply

Moons' SS03-S-A Specifications

General

Brand	Moons'
Model	SS03-S-A
Category	Servo Drives
Language	English