03/15
•
11
SAFETY
AVOID CONTACT WITH MOVING PARTS
There are hazards associated with V-belts, and chains. Objects or body parts can become crushed between V-belts ,pulleys,
chains, and sprockets. Stay away from these areas when the machine is running and follow Lockout/Tag out procedures
before adjusting or performing any maintenance on any of these systems.
Do not hand feed this machine for any reason�
DO NOT MODIFY MACHINE
Unauthorized modications to the machine may impair the function and/or safety and affect machine life. This will also void all
warranties.
NOTE: Before welding on machine equipped with an electronic engine, the following precautions should be observed:
1� Disconnect all cables to the machine batteries.
2� Disconnect both ECM connectors and all harnesses.
NOTE: Do not use the ECM or engine ground stud for grounding of the welder.
3� Locate the welding ground as close as possible to the welding area.
AVOID FIRES
• Never refuel with power unit running
• Never smoke, weld or have an open ame when refueling
• Use only in a well ventilated area and away from any sparks or ames
• Clean dirt, oil, chips and bark material from engine area
To Next Page
Loading...