03/15
•
23
REMOTE CONTROLS
RADIO CONTROL
The remote control transmitter and receiver provided with this machine have matched radio signals that prevents
unintentional operation by stray signals. However stray radio signals, high voltage power lines, and other forms of
interference can cause the remote control system to stop working or work erratically. To prevent injury to personnel or
machine damage, do not use the remote control system when interference is present. Under these conditions the machine
can be safely operated by using the manual controls.
TRANSMITTER
The remote control transmitter is equipped with an LED light to indicate the operating condition of the transmitter. When the
transmitter is switched to the on position, the LED light glows steadily GREEN for 3 seconds followed by a rapidly blinking
GREEN light (about 2 blinks per second.) This indicates that the unit is operating normally and that the batteries are in good
condition.
WARNING: If the LED fails to light when the unit is switched to the on position or the LED glows RED, the
batteries are low and must be replaced before machine operation begins� If the LED turns to RED during use,
safely stop all machine operations and replace the batteries� Failing to do so may cause the operator to lose
signal thereby stopping and losing control of machine functions� Use rechargeable AA alkaline batteries in this
transmitter�
WARNING: Improper operation of these controls can cause serious injury to personnel and damage equipment�
Do not allow anyone to operate this equipment before completely reading the manual�
CARE AND HANDLING OF SYSTEM
1� Transmitter should be turned off when not in use.
2� Do not store transmitter in direct sunlight or wet areas.
3� Handle transmitter with care. Do not drop, throw or subject to severe physical shock.
4� For reliable radio operation, stay within working radius. (For individual working distance refer to your OEM Manual.)
Specied operating ranges are based upon line-of-sight conditions. Physical obstructions especially those with high
metal content, may reduce operating range. Avoid obstructions or relocate receiver antenna.
5� Transmitter should face towards receiver antenna.
To Next Page
Loading...