03/15
•
29
SAFETY OPERATION
STARTING MACHINE
DANGER/ENTANGLEMENT HAZARD: Never hand-feed this machine for any reason�
CAUTION: Be sure hydraulic fluid levels are in the required range and all ball valves are open�
1� Turn battery disconnect (OPTIONAL) and key to start position.
2� Let power unit idle until all engine gauges reach normal operating range.
NOTE: In cold weather, it is good practice to let your hydraulic system idle with clutch engaged for approximately 15 minutes
before actual machine operation. In extremely cold weather, the cold oil will cause the pumps to cavitate.
3� Activate the button to engage the clutch or (if mechanical) set clutch handle into engage position.
4� Throttle up power unit all the way.
To Next Page
Loading...