What to do if Morita Veraview iX displays Error No. E00, E05, or E09?
If you see Error No. E00, E05, or E09 on your Morita Dental equipment, it indicates either abnormal head temperature or an overheated inverter, likely due to repeated use. To resolve this, turn off the unit and allow it to cool down.
What to do if Morita Veraview iX cannot expose X-ray?
If your Morita Dental equipment isn't exposing X-rays even when you push the emission key/button, ensure you hold the emission key/button down until the exposure is completed.
How to fix downtime until next emission operation in Morita Dental equipment?
To resolve downtime issues with your Morita Dental equipment, turn off the power supply. Once all the LEDs on the control panel are off, you can turn the power supply back on.
What to do if Ready Indicator on the Control Panel of Morita Veraview iX is flashing?
If the Ready Indicator on the Control Panel of your Morita Dental equipment is flashing, simply wait until the Ready Indicator lights up continuously.
Why Morita Veraview iX Dental equipment has no power when turned on?
If your Morita Dental equipment isn't getting power when you turn it on, the issue is 'No power supply'. Check the breaker on the distribution panel to ensure it is properly set.
How to stop the pole from going down by itself on Morita Dental equipment?
To fix the issue of the pole going down by itself on your Morita Dental equipment, take out the screw in the back of the support column and then remove the spacer.
Guidelines for users and dealers to prevent accidents and ensure safe operation.
Explanation of symbols indicating potential hazards and their severity.
Critical safety instructions for operating the X-ray unit to prevent injury or equipment damage.
Essential measures for radiation protection for patients and operators.
Procedure for powering on the unit and understanding its sleep mode.
Guide to selecting patient type, kV value, and imaging mode for exposures.
Procedure for choosing the specific tooth or area to be radiographed.
How to manually adjust the exposure time and save the settings.
Instructions for patient positioning, seat/height adjustment, and related safety precautions.
Safety warnings regarding weight limits and handling accessories during positioning.
Step-by-step guide for initiating and completing an X-ray exposure, including emergency stops.
Explanation of error code E00 and its corresponding remedy.
Guidance on identifying and resolving common operational problems and error codes.
Definition of essential performance criteria, including X-ray irradiation control and termination.
General| Type | Cone Beam Computed Tomography (CBCT) |
|---|---|
| Detector Type | Flat Panel Detector (FPD) |
| X-ray Tube Voltage | 60-90 kV |
| Software | i-Dixel |
| Patient Positioning | Standing or seated |
| Radiation Dose | Low dose options available, varies by FOV and settings |
| X-ray Tube Current | 1-10 mA |
To Next Page
