Mostek z80 - Page 41

3-5
This message is generated if the user attempts a Target access when the
'rarget progr~ is being executed. To terminate execution enter ESCAPE, then
atten1pt the access.
*** ERROR 66 MAXIMU/vl BREAKPOINTS EXCEEDED
This message is generated if the user attempts to set more than eight
software breakpoints.
*** ERROR 67 TARGET MEMORY FAILURE
This message is generated by the F command if the data fails to be filled
properly in RAM. The fill will be completed even tnough errors may occur.
*** ERROR 68 INVALID OPCODE
This message is generated if an attempt is made to disassemble an
undocumented 280 instruction.
*** ERROR 69 INVALID OPERAND
This message is generated if an attempt is made to disassemble a Z80
instruction with an invalid operand.
*** ERROR 6A INVALID C~~D TERMINATOR
This message is generated if an attempt is made to tenninate a command with
an invalid character.
*** ERROR 68 DATA ENTERED EXCEEDS FOUR BYTES
This message is generated if an attempt is made to enter more than four
bytes at time when entering code using the disasseHlbly mode of the M
corrunand.