MoTeC Configuration 45
Top Displays
The numeric displays can be programmed to display any channel value.
The numeric displays can show any channel value plus up to two override
values. Override values display each time their value is updated. This is
useful for values that are updated periodically. The override values are shown
for a programmable period of time. For example, a numeric display could
normally show the Running Lap Time (which is continuously updating), then
be overwritten by the Lap Time for 10 seconds each time the Lap Time is
updated.
The label above each of the numeric displays can be changed to suit the
channel assigned.
Centre Display
The centre display is normally used to display the current gear but can be
used for other purposes.
To Next Page
Loading...
Need help?
General