• Auto – Automatically displays the screen saver when the radio is inactive for a pre-
determined period.
• Disabled – Disables the screen saver.
• Text – To set the text on the screen saver when this feature is activated.
4.6.6.4
Setting Backlight
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup → Display → Backlight.
3 Select one of the following options:
• Auto – Backlight is triggered by turning on the radio, by pressing any key on the device or on
the accessory that is connected to it. Also charging or getting signal from the services like:
Call-Out message, RUA request, DGNA, TX timeout during priority call, and new SDS
messages are going to turn on the backlight.
• Semi Auto – Backlight is turned on when you are switching on the radio, pressing assigned
button to the backlight feature, or charging.
4.6.6.5
Setting Brightness
When and where to use: To set the luminance of the display and the keypad in an environment with
low visibility.
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup → Display → Brightness.
3 Select one of the following options:
• Level – Allows you to manually set the brightness level using the Up or Down Navigation
key.
• Automatic – Enables or disables the automatic brightness mode, in which the radio uses a
photo sensor to automatically adjusts brightness to the ambient light. However, it is still
possible to adjust brightness using the Up or Down Navigation key in the Level menu.
4.6.6.6
Setting Wallpaper
When and where to use: To change the look of the home screen.
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup → Display → Wallpaper.
3 Select one of the following options:
• On – To activate this feature.
• Off – To deactivate this feature.
MN003460A01-AE
Chapter 4: Main Menu
48
To Next Page
Loading...