4.6.7
Time and Date
This sub-menu controls the displayed time and date on the home screen.
NOTICE: If the Home Display Text Message feature is enabled, Home Mode Display Text may
cover time and date, depending on the Configurable Idle Screen settings. Infrastructure
synchronizes the time and date. When not within the infrastructure signal range you can set the
values manually.
4.6.7.1
Setting the Time Manually
When and where to use: If the time cannot update automatically through the infrastructure.
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup → Time & Date → Set Time.
3 Enter current time using Navigation keys.
Press Menu to switch between values.
4 Press Done.
4.6.7.2
Setting the Date Manually
When and where to use: If the time cannot update automatically through the infrastructure.
Procedure:
1 From the home screen, press the Menu key.
2 From the home screen, press the Menu/OK key.
3 Select Setup → Time & Date → Set Date.
4 Enter current time using Navigation keys.
Press Menu to switch between values.
5 Press Done.
4.6.7.3
Setting Time Offset
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup → Time & Date → Time Offset.
3 Enter time offset using Navigation keys.
NOTICE: You can adjust the offset value, with 15 minute steps, up to 14 hours ahead or
behind.
4 Press Done.
MN003460A01-AE
Chapter 4: Main Menu
49