Motorola solutions APX 8000 User Manual

7.10.5.1
Sending Remote Emergency to Specific Users
Procedure:
1 Press the programmed Remote Emergency button.
2 Select the required user of the target radio.
3 To send Remote Emergency, press the PTT button.
If the ID of the target radio is valid, your radio displays sending notification and saves the ID as the last
Remote Emergency ID.
If the ID of the target radio is invalid, your radio displays an invalid ID notification.
If your radio is in one of the following states, your radio plays a tone.
• Receive-only Channel
• Transmit Inhibit
• Out of Range
• Imbalance Coverage
If your radio receives acknowledgment, your radio displays a positive notification.
If your radio does not receive acknowledgment from the target radio, your radio displays a negative
notification.
7.10.5.2
Manually Refreshing the Remote Emergency List
Procedure:
1 Press the programmed Remote Emergency button.
2 To refresh the remote emergency list, press Rfsh.
Your radio displays List refreshed followed by the updated remote emergency list..
7.10.5.3
Receiving Remote Emergency
The remote emergency will only be launched if your radio has the emergency enabled. The receiving
radio displays Emergency.
Procedure:
To exit the emergency operation, press and hold the programmed Emergency button.
MN001424A01-AW
Chapter 7 : Advanced Features
68

Motorola solutions APX 8000 Specifications

General

Brand	Motorola solutions
Model	APX 8000
Category	Two-Way Radio
Language	English