AP-7131 Access Point Product Reference Guide
4-56
FAIL: user interrupted
FAIL: no valid interface found
FAIL: conflict ip address
FAIL: command exchange time out
FAIL: invalid subnet number
11. Confirm the access point configuration is the same as it was before the firmware update. If
they are not, restore the settings. Refer to Importing/Exporting Configurations on page 4-46
for instructions on exporting the configuration back to the access point.
12. Click Apply to save the filename and filepath information entered into the Firmware Update
screen. The Apply button does not execute the firmware, only saves the update settings
entered.
13. Click Undo Changes (if necessary) to undo any changes made. Undo Changes reverts the
settings displayed on Firmware Update screen to the last saved configuration.
14. Click Logout to securely exit the access point Access Point applet. A prompt displays
confirming the logout before the applet is closed.
To Next Page
Loading...
