Motorola AP-7131 - Page 373

8-45
AP7131>admin(network.wan.nat)> add
Description:
Adds NAT entries.
Syntax:
Example:
admin(network.wan.nat)>add 1 indoors udp 20 29 10.10.2.2
admin(network.wan.nat)>list 1
-----------------------------------------------------------------------------
index name Transport start port end port internal ip translation
-----------------------------------------------------------------------------
1 indoor udp 20 29 10.10.2.2 0
Related Commands:
For an overview of the NAT options available using the applet (GUI), see Configuring Network Address Translation (NAT) Settings on
page 5-21.
add <idx> <name> <tran> <port1> <port2> <ip> <dst_port>
Sets an inbound network address translation (NAT) for WAN address <idx>, where <name> is the name of the entry
(1 to 7 characters), <tran> is the transport protocol (one of tcp, udp, icmp, ah, esp, gre, or all), <port1> is the starting
port number in a port range, <port2> is the ending port number in a port range, <ip> is the internal IP address, and
<dst_port> is the (optional) internal translation port.
delete Deletes one of the inbound NAT entries from the list.
list Displays the list of inbound NAT entries.