8-249
AP7131>admin(system.fw-update)>update
Description:
Executes the access point firmware update over the WAN or LAN port using either ftp or tftp.
Syntax:
admin(system.fw-update)>update ftp
For information on updating access point device firmware using the applet (GUI), see Updating Device Firmware on page 4-50.
update <mode><iface> Defines the ftp ot tftp mode used to conduct the firmware update. Specifies whether the
update is executed over the access point’s WAN, LAN1 or LAN2 interface <iface>.
NOTE The access point must complete the reboot process to successfully update the device firmware,
regardless of whether the reboot is conducted uing the GUI or CLI interfaces.
To Next Page
Loading...
