Configuring Mesh Networking
9-27
3. Create a mesh supported WLAN with the Enable Client Bridge Backhaul option
selected.
4. Select the Client Bridge checkbox to enable client bridge functionality on the 802.11a/n
radio. Use the Mesh Network Name drop-down menu to select the name of the WLAN
created in step 3.
NOTE This WLAN should not be mapped to any radio. Therefore, leave both of
the “Available On” radio options unselected
NOTE You don't need to configure channel settings on the client bridge (AP#3). It
automatically finds the base bridges (AP#1 and AP#2) and uses the
channel assigned to them.
To Next Page
Loading...
