Preparing Your Radio for Use
English
10
Plug the earpiece to the wireless Pod.
With your Pod and your radio powered up and both are in
pairing mode, place the Bluetooth pairing spot on your Pod
within one inch of the Bluetooth pairing spot on your radio.
Your radio Blue LED lights up solid for 2 seconds once
connected and followed by blinking blue at heartbeat pace to
indicate there is Bluetooth device connected to your radio.
Note: Ensure the microphone is not covered when you speak
into the microphone.
Your Pod can function as a standalone PTT device
without the headset.
Pairing Radio with Key Fob
Verify that both your radio and key fob are powered ON and in
pairing mode.
On your key fob,
press and hold the
Trunk button while
powering up your key
fob to enter pairing
mode.
Place the Bluetooth
pairing spot of your
key fob within one
inch of the Bluetooth
pairing spot of your
radio.
Your radio Blue LED
lights up solid for 2
seconds once connected and followed by repeats long blinking
to indicate there is Bluetooth device connected to your radio.
Bluetooth Pairing Spot
APX_3000_M1.book Page 10 Wednesday, October 17, 2012 12:56 PM
To Next Page
Loading...
Need help?
General
