General Radio Operation
English
26
Using Mode Select Feature
Mode Select allows a long press to save your radio’s current
zone and channel to a programmable button. Once it saved, a
short-press of the button jumps the transmission to the saved
zone and channel.
To save the selected zone and channel, press the
preprogrammed button.
Note: Your radio must be preprogrammed to allow you to use
this feature.
Saving a Zone and Channel to a Mode Select
Button†
This feature allows to save two different zones or channels to a
preprogrammed button.
Procedure:
1 Toggle your zone and channel to the required zone and
channel.
2 Press the preprogrammed button to save the zone or
channel.
3 You hear a short, medium-pitched tone when the zone and
channel is saved.
Note: To change the programmed zone and channel, repeat
this procedure.
Saving a Zone and Channel to a Button†
Save the frequent used zone and channel to a preprogrammed
Mode Select button.
Procedure:
1 Toggle your zone and channel to the required zone and
channel.
2 Press and hold the digit button you desire to program.
3 You hear a short, medium-pitched tone when the zone and
channel is saved.
Note: Repeat this procedure to change the zone and channel
of the programmed button.
Short press of the programmed button changes your current
transmission to the zone and channel programmed in this
button.
APX_3000_M1.book Page 26 Wednesday, October 17, 2012 12:56 PM
To Next Page
Loading...
Need help?
General
