Advanced Features
English
42
Testing the Man Down Feature
Note: Enable the Emergency feature with Silent Alarm
disabled, but not in Surveillance Mode before running
this test on your radio.
Procedure:
When Man Down is enabled on your radio:
1 Turn your radio on and place in the vertical position, for at
least 5 seconds.
2 Lay your radio down in the horizontal position.
3 Wait for alert tone.
4 Your radio alerts with audible tone and displays MAN-
DOWN.
OR
If no tone is heard, make sure that the Man Down feature is
enabled on your radio. If Man Down feature was not
enabled, please enable it and go through steps 1,2 and 3
again.
OR
If the Man Down feature is enabled and no tone is heard,
send your radio to a qualified technician.
Handling Man Down Functional Error Messages
Procedure:
1 If your radio display shows one of the following error
messages: HW BOARD ABSENT, MAND HW ERROR or HW
BRD MISMATCH. Send your radio to the qualified technician
to fix this error.
APX_3000_M1.book Page 42 Wednesday, October 17, 2012 12:56 PM
To Next Page
Loading...
Need help?
General
