EasyManuals Logo

Motorola ASTRO APX 6000XE Series User Manual

Motorola ASTRO APX 6000XE Series
194 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
Preparing Your Radio for Use
English
6
Attaching the Accessory Connector
Cover
The accessory connector is located on the antenna side of the
radio. It is used to connect accessories to the radio.
Note: To prevent damage to the connector, shield it with the
connector cover when not in use.
Insert the hooked
end of the cover
into the slot above
the connector.
Press downward on
the cover’s top to
seat it in the slot.
Once in place,
tighten by rotating
the thumbscrew
clockwise by hand.
To remove the accessory connector cover, rotate the
thumbscrew counterclockwise until it disengages from the radio.
If the thumbscrew is too tight, use an Allen wrench to loosen
it first.
Rotate and lift the connector cover to disengage it from
the radio.
Using the Carry Holder
Position the radio within
the carry holder with the
main speaker facing
outward. Slide the radio
down into the carry
holder until it clicks in
place.
Hooked End
Thumbscrew
Hex Socket Head

Table of Contents

Other manuals for Motorola ASTRO APX 6000XE Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Motorola ASTRO APX 6000XE Series and is the answer not in the manual?

Motorola ASTRO APX 6000XE Series Specifications

General IconGeneral
Frequency Range700/800 MHz, VHF, UHF Range 1, UHF Range 2
Operating Temperature-30°C to +60°C
P25 Phase 1 & 2Yes
BluetoothYes
GPSYes
Weight381 g (with standard battery)
EncryptionAES, DES-OFB
Intrinsically SafeYes

Related product manuals