General Radio Operation
English
28
4 Press the Menu Select button directly below CHSR once the
entry is done to initiate searching.
OR
Press the Menu Select button directly below CNCL to exit.
5 The display shows SEARCHING.
OR
If the radio is triggered to search for an empty entry, the
display shows INVALID ENTRY. Repeat step 3.
6 Once found, the display shows the matched channel name
and the radio changed its transmission to this channel.
OR
If the entry does not match, the display shows CHANNEL
NAME NOT FOUND. Repeat from step 3 if want to search
again; or press H or the Menu Select button directly below
EXIT to exit.
Using Mode Select Feature
Mode Select allows a long press to save the radio’s current
zone and channel to a programmable button, keypad button or
a softkey; then once programmed, the short-press of that button
or softkey jumps the transmission to the saved zone and
channel.
There are two methods to save the selected zone and channel:
• Softkeys
• Programmable buttons and keypad buttons (digit 0 to 9)
Note: Your radio must be preprogrammed to allow you to use
this feature.
O5Head_6875947m01.book Page 28 Tuesday, November 1, 2011 12:06 PM