53
Special Radio Features
4
Special Radio Features
Dynamic Regrouping
The dynamic regrouping feature allows the dispatcher to temporarily
reassign selected radios to a single special channel so that they can
communicate with each other. This feature, enabled in each radio by means
of the radio service software, is typically used during special operations. You
will not notice whether your radio has this feature enabled until a dynamic
regrouping command is sent by the dispatcher.
If you select the dynamic-regrouping zone/channel using
softkeys or other radio controls without being dynamically
regrouped, an invalid tone will be heard.
1. When your radio has been dynamically regrouped, you will hear a
“gurgle” tone (unless you are already on the dynamic-regrouping
zone/channel), and your radio will be automatically switched to the
dynamic-regrouping channel. The display will show the name
assigned to the dynamic-regrouping channel.
If you are using a radio control knob or switch (not softkeys) to
select the zone or channel — Until you select the correct
dynamic-regrouping position, you will not be able to select
scan, telephone call, or Private Conversation call feature, and
you will hear a gurgle tone each time you press the
PTT Switch
.
This is a reminder to you that you are transmitting on the
dynamic-regrouping channel, not the zone or channel
indicated by the position of the radio control.
If your radio is programmed as a
select-enabled radio: Once you
select the correct dynamic-regrouping position, you can
change the radio’s zone or channel knob/switch position, press
the
PTT Switch
, which will transmit on the dynamic-
regrouping zone/channel, and you will not hear the “gurgle”
tone.
Note
Note
Exception to this Note
To Next Page
Loading...
