4 - 16 DS9208-1D Product Reference Guide
Momentary Trigger Mode Timeout
Parameter # EDh
In momentary trigger mode, the aiming dot appears upon pressing the trigger. Once in this mode, upon each
trigger press the scanner attempts to decode the bar code in front of it. After a period of inactivity while the
trigger is not pressed, the scanner reverts to presentation mode where there is no illumination until an item is
presented.
This parameter controls the length of the period of inactivity in momentary trigger mode before the scanner
reverts to presentation mode.
Momentary Trigger Mode Timeout - 2 Seconds
(14h)
Momentary Trigger Mode Timeout - 3 Seconds
(1Eh)
Momentary Trigger Mode Timeout - 4 Seconds
(28h)
*Momentary Trigger Mode Timeout - 5 Seconds
(32h)
To Next Page
Loading...
