Motorola DS9208-1D User Manual

APPENDIX A STANDARD DEFAULT
PARAMETERS
Table A-1 Standard Default Parameters Table
Parameter
Parameter
Number
Default
Page
Number
User Preferences
Set Default Parameter Set Defaults 4-4
Parameter Bar Code Scanning ECh Enable 4-5
Beep After Good Decode 38h Enable 4-5
Beeper Tone 91h Medium 4-6
Beeper Volume 8Ch High 4-7
Volume Adjustment Trigger Timeout F0h 93h 5.0 Sec 4-8
Beeper Duration F1h 74h Medium 4-9
Suppress Power-up Beeps F1h D1h Do not suppress 4-9
Low Power Mode 80h Disable 4-10
Time Delay to Low Power Mode 92h 1 Hour 4-11
Trigger Mode 8Ah Presentation 4-13
Trigger Aiming Pattern F0h 32h Enable 4-14
Presentation Aiming Pattern F1h 4Eh Disable 4-15
Momentary Trigger Mode Timeout EDh 5 sec 4-16
Motion Detect Range F2h 3Bh Full 4-17
Decoding Illumination
(Hand-Held Mode Only)
F0h, 2Ah Enable 4-18
1
User selection is required to configure this interface and this is the most common selection.

Motorola DS9208-1D Specifications

General

Brand	Motorola
Model	DS9208-1D
Category	Scanner
Language	English