Accessories 6 - 19
Cables
This section describes how to set up and use the cables. The cables are available with a variety of connection
capabilities.
The following communication/charge cables are available:
•
Serial (RS232) Charge cable (9-pin D female with power input receptacle)
•
USB Client Charge cable (standard-A connector and a barrel receptacle for power)
•
Auto charge cable
•
DEX cable
•
Modem inverter cable
•
Charge only cable.
The following printer cables are available directly from Motorola:
•
O’Neil Printer cable
•
Zebra Printer cable.
Figure 6-21
Cables
Communication/charge cables:
•
Provide the MC75 with operating and charging power when used with the Motorola approved power supply.
•
Synchronize information between the MC75 and a host computer. With customized or third party software, it
can also synchronize the MC75 with corporate databases.
•
Provide serial connection through the serial pass-through port for communication with a serial device, such
as a host computer. For communication setup procedures, refer to the MC75 Integrator Guide.
•
Provide USB connection through the USB pass-through port for communication with a USB device, such as
a host computer. For communication setup procedures, refer to the MC75 Integrator Guide.
Dedicated printer cables provide communication with a printer.
Battery Charging and Operating Power
The communication/charge cables can charge the MC75 battery and supply operating power.
To charge the MC75 battery:
1. Connect the communication/charge cable power input connector to the Motorola approved power source.
To Next Page
Loading...
