5.1 - 6 TEST SETUP & TESTING for 380–430 MHz and 410–470 MHz
k. Press the "Highest Channel" soft key and enter "1199" for 380–430MHz ("2799"
for 410
–470MHz) using the data keys followed by the "Highest Channel" soft key.
l. Press the "Lowest Tx Freq" soft key and enter "411.0125" for 380
–430MHz
("461.0125" for 410–470MHz) using the data keys followed by the "MHz" key.
m.Press the "Duplex Offset" soft key and enter "10" for 380
–430MHz/ 410–470MHz
using the data keys followed by the "MHz" key.
n. Press the "Channel Spacing" soft key and enter "25" using the data keys followed
by the "kHz" key.
o. Press the "Return" soft key.
p. Verify that channel block 2 to 8 are excluded.
q. Press the "Return" soft key.
9. Press the "Control Channel" soft key and enter "840" for 380
–430MHz ("2440" for
410
–470MHz) using the data keys followed by the "Control Channel" soft key.
10. Press the "Traffic Channel" soft key and enter "840" for 380
–430MHz ("2440" for
410
–470MHz) using the data keys. Press the "Traffic Channel" soft key again and
check that the marker goes to Timeslot. Press data key "3" followed by the "Traffic
Channel" soft key, to change to Timeslot "3".
11. Press the “Country Code” soft key.
Enter “262” and press the “Country Code” soft key.
12. Press the “Network Code” soft key.
Thereafter, enter “75” and press the “Network Code” soft key.
13. Press the “Base Color” soft key.
Thereafter, enter “1” and press the “Base Color” soft key.
14. Press the “Location Area” soft key.
Thereafter, enter “224” and press the “Location Area” soft key.
15. Press the “Min Rx Level” soft key.
Thereafter, enter “-110dBm” and press the “Min Rx Level” soft key.
16. Press the “Max Tx Level” soft key.
Thereafter, enter “35dBm (3.2W)” and press the “Max Tx Level” soft key.
17. Press the “Access Parameter” soft key.
Thereafter, enter “-33dBm” and press the “Access Parameter” soft key.
18. Press the “Test Mode” soft key. Press the “Enable” soft key.
19. Press the “Base Service” soft key.
20. Press the “Suport” soft key if it is displayed
or verify that the following values are displayed:
POWER ON REGISTRATION: REQUIRED
POWER OFF DE-REGISTRATION: REQUIRED
PRIORITY CELL: YES
MINIMUM MODE SERVICE: NEVER USED
MIGRATION: SUPPORTED
SYSTEM WIDE SERVICE: NORMAL MODE
TETRA VOICE SERVICE: SUPPORTED
To Next Page
Loading...
Need help?
General
