• Low — the icon is displayed with the New WAP Message tone.
Note: Browser does not open if you are in a call, or in Emergency Mode, or in Call Out, or in message
editor, or PIN lock state, or switching to DMO.
Viewing WAP Messages
Procedure:
1 From the home screen, press the MENU key.
2 Select Messages → WAP Box.
3 Select the required message.
4 Select Go to to view the message in the browser.
Call-Out
This feature allows you to receive Call-Out alerts. On receiving the Call-Out messages, the radio interrupts current
services and attends to the Call-Out alert without any further delay. After call-out alert has been cleared, the radio
exits Call-Out mode and reverts to normal mode. During Call-Out mode you are only able to receive Emergency
Calls.
Note: To read an entire Call-Out message, scroll down the screen by pressing the down NAVIGATION key.
The length of the message is indicated by the vertical red bar on the left of the screen.
Figure 3: Call-Out Message
Note: This is a selling feature.
Related Links
CO Box on page 61
Types of Call-Out Alerts
There are four types of the Call-Out alerts:
• Normal Call-Out – an alert message that is sent by a dispatcher either to a single radio or to a group of radios.
• Storm Plan – an alert message that is sent by a dispatcher to a group of radios. To raise its reliability, it is sent
several times. You are not able to respond to the Call-Out alert and any key press takes you to the information
phase.
• Fallback Mode – an alert message that is limited only to voice communication. To initiate this type of Call-Out,
press a One-Touch key predefined by your service provider. It can be cleared manually.
Note: Fallback is only possible when the radio is in Local Site Trunking.
• Test Call-Out – a special Call-Out alert that is sent by the dispatcher to test this feature. On receiving the Test
Call-Out, the radio plays a tone and displays Test Call-Out. To respond and clear the alert, press the Test
OKSOFT key.
Features | 101
| | Send Feedback
To Next Page
Loading...
