• Duplex Vol — sets the volume level for duplex ringtones.
• Simplex Vol — sets the volume level for simplex ringtones.
• Earpiece Vol — sets the volume level for the earpiece.
• Speaker Vol — sets the volume level for the speaker.
• Keypad Vol — sets the volume level for keypad tones.
Note: If the display shows only one option Volume, you can adjust all of the above settings at once.
You have the option to change the settings individually when the Volume Adj. Mode is set to
Individual.
4 Press right or left NAVIGATION key to change the value.
Related Links
Setting Volume Adjustment Mode on page 73
Language
This sub-menu allows you to change the language of the radio.
Setting Language
Procedure:
1 From the home screen, press the MENU key.
2 Select Setup → Language.
3 Select desired language.
Data Setup
This menu item allows you to set up your radio to transmit and receive data from the external device.
To connect your radio accessory connector to the external device, use the GMKN1022 cable. The external device
must run an application complying with the TETRA standards.
Note:
• Data services are available only in TMO Mode.
• Data services are blocked in TXI Mode.
Setting Data Function
Procedure:
1 From the home screen, press the MENU key.
2 Select Setup → Data Setup.
3 Select one of the following:
• Voice Only — Your radio receives and transmits voice calls only.
• Data Only — Your radio acts as a modem. It rejects incoming and outgoing voice calls (except for Emergency
Calls), status and text messages.
• Voice & Data — Your radio acts as a modem but voice calls have priority over data calls and can interrupt
them.
Audio
This menu item allows you to adjust your radio audio settings.
72 | Main Menu
Send Feedback | |
To Next Page
Loading...
