Feature Description
RMS Mode (applicable only for * and #) Toggles on/off RMS feature.
Rotary Switches Lock/Unlock Locks/unlocks the Rotary Switches.
RUA/RUI Log On/Off Asks for the credential or logs off the radio.
Screen Saver Activation Turns on/off the Screen Saver feature.
Sending Predefined Message Sends a predefined message to a dedicated address.
Sending Status Sends a dedicated status message to a dedicated address.
Sending User Defined Message Sends a user defined message to a dedicated address.
Speaker Enable/Disable Per Call Enables the loudspeaker for a duration of the ongoing call..
Timed Talkgroup Change Makes a predefined talkgroup the selected talk group for a specified
amount of time. While using the predefined talkgroup, the second
press of the One-Touch Button results in: returning to the previously
selected talkgroup, restarting the predefined time, or no action
(depending on configuration). After the timer expires, the radio
returns to the previously selected talkgroup.
TMO / DMO Switch Toggles between TMO and DMO modes.
TMO Talkgroup Scan Turns on/off the Talkgroup Scan feature in TMO Mode.
Transmit Inhibit Mode (TXI) Turns on/off the Transmit Inhibit Mode.
Your service provider can assign one-touch functions only to the side buttons and keypad keys.
Note: If the One-Touch Button feature is enabled, the One-Touch Dial is disabled. If no feature is assigned
to a button, your radio displays an Unassigned Button message.
Terminal Temporary Disable/Enable
Your radio is provided with a feature that allows your service provider to disable it temporarily in case it is stolen.
When your radio is disabled or is powered up in disabled state, it looks and acts like it is turned off.
If your radio is found, your service provider can enable it again over the air. After your radio is enabled, you may
resume normal operation.
Terminal Permanent Disable
Your radio is provided with a feature that allows your service provider to disable it permanently in case it is stolen or
lost. When your radio is disabled permanently, it becomes inoperable. After a Permanent Disable your service
provider cannot enable your radio. It is recommended to Permanent Disable your radio only when you do not expect
to recover it. If it is recovered then a Permanent Disable radio can be reactivated by returning it to Motorola.
Note: This is a selling feature.
Getting Started | 29
| | Send Feedback
To Next Page
Loading...
