capable of controlling other radios. During the execution of the Remote Control messages, depending on your service
provider settings, the radio can play a tone, vibrate, or display an appropriate icon in the status icon area.
Note: This is a selling feature.
Setting SDS Remote Control
When and where to use: To enable/disable support of special SDS messages that allow remote control of the radio.
Procedure:
1 From the home screen, press the MENU key.
2 Select Security → Remote Control.
3 Select On to enable, or Off to disable remote control.
Setup
This sub-menu allows you to change your radio configuration.
Ring Style
This sub-menu allows you to set the incoming call ring style.
Setting Ring Style
Procedure:
1 From the home screen, press the MENU key.
2 Select Setup → Ring Style.
3 Select one of the following:
• Duplex — To set the new ring style to all duplex calls.
• Simplex — To set the new ring style to all simplex calls.
Note: Upon entry into this sub-menu, the display shows the current ring style used.
4 Scroll to the desired style and press Select.
Note: New ring style is played immediately for a few seconds. If necessary, adjust the volume level.
Set Volume
This menu item allows you to adjust the Simplex, Duplex, Earpiece, Speaker, and Keypad tone volume.
Related Links
Volume Adjustment Mode on page 73
Setting Volume
Procedure:
1 From the home screen, press the MENU key.
2 Select Setup → Set Volume.
3 Select one of the following:
Main Menu | 71
| | Send Feedback
To Next Page
Loading...
