Using Any Network
When and where to use: Your radio has lost its home network coverage and can register to any network. Only clear
authentication is supported on any network.
Procedure:
1 From the home screen, press the MENU key.
2 Select More . . . → Networks → Networks Sel → Any Network.
3 Your radio selects and registers to the network automatically from the predefined list.
Using the Migrate To Registration
When and where to use: Use this feature to migrate to another predefined network, when you are out of the range of
your network and your radio displays the No Service message.
Procedure:
1 From the home screen, press the MENU key.
2 Select More . . . → Networks → Networks Sel and choose one of the following option:
• Migrate to... — Selects the required network form the list. To view the network ID press MENU key then
press Select.
• Auto — Your radio automatically attaches to the predefined network.
Location
See the GPS Location Service for more information.
Related Links
GPS Location Service on page 51
Viewing Your Position
Procedure:
1 From the home screen, press the MENU key.
2 Select More . . . → Location → Position.
3 Scroll to view the results about the last time your location was calculated.
Note: To refresh your position:
• Select Position — the radio refreshes its position automatically
• Press Refresh
Packet Data
The Packet Data (PD) Service allows you to transfer data in a TETRA system using the Internet Protocol (IP).
Note: To transfer data from a standard computer over the air, connect the computer via the data cable
GMKN1022 with your radio. Your service provider has to setup additional applications on your computer.
If set up by your service provider it is possible to accelerate the transmission by using the Multi-Slot Packet Data
(MSPD) Service.
Main Menu | 87
| | Send Feedback
To Next Page
Loading...
