Message Message Description
No Service Your radio is out of coverage.
Not Allowed To Initiate Call You are not allowed to dial a number which is not in the address
book.
Not Allowed To Transmit Release the PTT button and try again later. You are not allowed to
send a text message or a status message to a number which is not in
the address book.
Single TalkGroup Only There is only one programmed entry in the scrolling list.
Overheating, Please Turn Radio Off Your radio turns off. Keep it turned off for 5 minutes.
Party Busy Called radio is busy.
Party Not Available Called radio is out-of-range or turned off. Please try again later.
Please Try Again You could not call.
Please Wait Connecting A message during startup.
Registration Failure Your radio could not register within the system. Please try again later.
Repeater available Your radio has connected to a repeater.
Repeater not available Your radio cannot connect to a repeater, or connection has been lost.
Service Denied Invalid number. Call your service provider.
Service Not Available This service is not available on the current network.
Service Restricted This service or feature is restricted by your service provider, it has
not been purchased, or it is not available.
TalkGrp ... cannot be deleted Your service provider set this group so you cannot delete it from the
favorite talkgroup folder.
Try Again Later The requested service is temporarily unavailable.
Radio Disabled Check with your service provider.
Unit is OK
Warn:
Self-test error. A minor fault has been detected. Your radio is still
fully operative. If this error recur, note the error code and contact
service.
Unit Not Attached You radio could not attach to the system. The talkgroup may not be
defined in the system. Please try another group.
Unassigned Button The message is displayed when no feature is assigned to a button.
CP setting error:
CH Role Selection
CH is powering OFF
The message is displayed when the control head configured as Slave
is connected to the Transceiver and the control head configured as
Master is connected as standalone (i.e. not to the Transceiver).
Standalone Mode
Radio is powered OFF
No available services
The message is displayed on Slave Control Head in Standalone mode.
Software Error:
The message is displayed on Slave Control Head only when the
software version is different than on Master.
Table continued…
Troubleshooting | 109
| | Send Feedback
To Next Page
Loading...
