15
Powering On/Off (On-Off/End/Home Key)
To p ow e r On, press and hold . Your MTP850 Ex/MTP810
Ex performs a self-check and registration routine. After
successful registration, the MTP850 Ex/MTP810 Ex is in
service.
To p o w e r Off
,
press and hold . You will hear a beep and
the Powering Off message is displayed.
Powering On (Emergency Button)
Press and hold the Emergency button to power On.
The MTP850 Ex/MTP810 Ex will power On in Emergency
Operation or in standard mode (as programmed).
Powering On with Transmit Inhibit (TXI) Active
Transmit Inhibit is a feature allowing you to switch off
transmission before entering a Radio-Frequency (RF)
sensitive area. To activate this feature, press and
select More...> Networks > TXI Mode > Activate.
The TXI Mode remains active at power On. You will be asked
whether to leave the TXI Mode On or not.
The terminal powers On and Off without visible and audible
notification if Covert Mode is activated. (Refer to “Covert Mode”
on page 35.)
Pressing the Emergency button, even if
Transmit Inhibit is activated, causes the
MTP850 Ex/MTP810 Ex to transmit immedi-
ately. The MTP850 Ex/MTP810 Ex must NOT
be within the RF sensitive area when entering
Emergency Operation.
Ensure you have left the RF sensitive area
before deactivating Transmit Inhibit.
To Next Page
Loading...
