77
Power off in Silent Emergency mode
If user initiates the power off while in Silent Emergency mode
the terminal goes to pseudo power off state. In this state
audio and visible indications are turned off but the terminal is
still on in the Silent Emergency mode as before.
Power on in pseudo power off
User presses the Emergencey button, the terminal indicates
power on but it is still in Silent Emergency mode.
Emergency in DMO
Overview
You can initiate an Emergency Group Call to a group.
You can receive an Emergency Group Call:
• From the selected talkgroup
• From other users within talkback range (if configured by
your Service Provider). This is called an InterMNI call.
• From an open group. (An open group is a super-group to
which all DMO groups belong.)
Emergency calls can be placed via gateway and repeater.
For gateway and repeater settings, see “Gateway/Repeater
Selection” on page 52.
Changing Folder or Group
Proceed as explained in the Group Call section, page 40.
Making an Emergency Group Call
To initiate or answer a call:
1. Enter Emergency Mode by pressing the Emergency button.
2. Press and hold PTT.
3. Wait for the talk permit tone (if configured) and talk.
If the terminal exits the Silent Emergency mode after powering
off in it, the terminal shuts down without any indication.
To Next Page
Loading...
