Motorola PM400 User Manual

41
English
PHONE
PHONE
Your radio allows you to place and receive
telephone calls through a repeater (depending
on phone line availability). You can edit the
phone list through your radio’s menu (see
page 44).
The phone feature is available in both
conventional and LTR systems.
• D appears on the display when you are in
Phone mode.
Your dealer/programmer can preprogram your
radio in one of three ways to enter your
access/de-access code to the repeater.
Immediate Auto – your radio will transmit the
access/deaccess code automatically upon
entering phone mode or disconnecting a
phone call. You will hear a series of tones, and
see your access/deaccess code on the display,
indicating that an access/deaccess code is
being sent automatically.
Delayed Auto – your radio will transmit the
access code upon a PTT button press. The de-
access code is sent automatically when you
exit phone mode.
Manual - Enter your access/deaccess code
using the DTMF microphone keypad and press
the PTT button.
RECEIVE A PHONE CALL D
When a phone call is received, a ringing tone
sounds, alerting you to answer the phone call.
Press the preprogrammed Phone button (see
page 18), and skip to step 6.
– or –
Press the PTT button, and if the Hot Keypad
feature has been preprogrammed by your
dealer/programmer, do the following:
1
G or H to select a channel/talkgroup that
has been programmed for telephone.
2
D to enter menu mode.
3
G or H until
4
D to select
Note: The D appears on the display.
PHONE
PHONE
05_Phone.fm Page 41 Monday, August 2, 2004 3:22 PM

Motorola PM400 Specifications

General

Frequency Range	VHF: 136-174 MHz, UHF: 403-470 MHz
Channel Spacing	12.5/20/25 kHz
IP Rating	IP54
Power Output	VHF: 1-25W, UHF: 1-25W
Weight	335g (with standard battery)
Signaling	DTMF
Operating Temperature	-30°C to +60°C
Channel Capacity	64 channels