Motorola PM400 User Manual

30
English
RADIO CALLS
SEND A SELECTIVE CALL
(CONVENTIONAL OPERATION ONLY)
You can send a Selective Call to a particular
radio or to a group of radios, as programmed
by your dealer/programmer.
Press the preprogrammed Radio Call button
(see page 18), and proceed to step 4.
–
or –
RECEIVE A CALL ALERT™ PAGE F
(CONVENTIONAL OPERATION ONLY)
When you receive a Call Alert page:
• The display shows F and the prepro-
grammed name or ID of the calling radio.
• The yellow LED indicator flashes, if pro-
grammed by your dealer/programmer.
• You hear four high-pitched tones.
To acknowledge the page, press and release
the PTT button; to cancel the page, press any
other key.
1
D to enter menu mode
2
G or H until
3
D to select
4
G or H until
5
D to select
6
G or H to locate the desired ID in the Call
List.
- or -
When using the enhanced keypad micro-
phone, enter a valid DTMF digit to move to
that location in the list.
RAD CALL
RAD CALL
SEL CALL
SEL CALL
7
Press the PTT button to send the call.
8
Press and hold the PTT button to talk; release
to listen.
9
When the call is completed,
C until you exit menu mode.
03_RadioCall.fm Page 30 Monday, August 2, 2004 3:01 PM

Motorola PM400 Specifications

General

Frequency Range	VHF: 136-174 MHz, UHF: 403-470 MHz
Channel Spacing	12.5/20/25 kHz
IP Rating	IP54
Power Output	VHF: 1-25W, UHF: 1-25W
Weight	335g (with standard battery)
Signaling	DTMF
Operating Temperature	-30°C to +60°C
Channel Capacity	64 channels