NOTICE:
If the user has disabled TX Inhibit using the
menu and then moves the switch to the
position where TX Inhibit is enabled, the new
value overwrites the menu value.
The display shows Tx inhibit on. You hear a
sequence of short, low-high tones to indicate
transmission is inhibited.
Pressing PTT triggers the radio sounds a constant short,
low-pitched tone (reject tone).
NOTICE:
The status of the Transmit Inhibit does not change
after the radio powers up.
Disabling Transmit Inhibition
Perform one of the following actions:
• Switch the preprogrammed Transmit Inhibit
switch to Transmit Inhibit disabled position.
• or to TxIn. Press the Menu Select button
below TxIn.
• Press the Transmit Inhibit programmable button.
NOTICE:
If the user has disabled TX Inhibit using the
softkey and then moves the switch to the
position where TX Inhibit is enabled, the new
value overwrites the menu value.
The display shows Tx inhibit off. You hear a
sequence of short, high-low tone (Transmit Inhibit
Off tone) to indicate transmission is back to normal
operation.
Instant Recall
This feature allows the user to save the last received call
and playback the recorded call.
The feature buffers all incoming audio over the air and
stored when the audio is saved.
Saving and Playback Calls
Perform one of the following to save and playback the
recorded calls. You can use the options interchangeably
English
211
To Next Page
Loading...
