Preparation for Washing the Radio and
Parts
You can detach the battery and Universal Connector Cover
of the radio and have them and the radio brushed and
washed with detergent and water.
Prepare the following material, apparatus or equipment
before you begin washing the radio and parts.
• A bucket of tap water (water height must be at least 2
inches higher than radio height).
• A bucket of 0.5% liquid detergent solution (1 teaspoon
of recommended liquid detergent to 1 gallon of water or
1 part recommended liquid detergent to 200 parts water;
water height must be at least 2 inches higher than radio
height).
• A small brush
• A toothbrush
• Source of running water
• Drying towel
Washing The Radio
1 Submerge the radio (with battery attached)
completely into the tap water while shaking it for
approximately 20 seconds.
2 Remove the radio from the water and perform the
following. Turn the frequency knob all the way from
position 1 to 15 and back to position 1 twice.
a Turn the volume knob all the way from the
minimum off position to its maximum volume
position and back twice.
b Turn the 3-Position A/B/C switch from A to C and
back to A twice.
English
24
To Next Page
Loading...
